Series and Parallel RC Circuits
LAB3
Series and Parallel RC Circuits
Analysis:
1. For Laboratory Application Assignment on pg. 555 examine Fig. 18-37.
2. Perform the following calculations:
o Xc
o Z1
o I
o Vc
o Vr
o thetaZ
3. Examine Fig. 18-38a and perform the following calculations:
o Xc
o Ic
o Ir
o It
o Zeq
o theta1
4. Scan all calculations showing all work in a file called “Lab3_Analysis_StudentID”.
5. Upload file “Lab3_Analysis_StudentID”
Simulation:
1. Construct the circuit in Fig. 18-37 with MultiSIM.
2. Measure the following values with a DMM:
o I
o Vc
o Vr
o Vt – requires a calculation
o Xc – requires a calculation
o thetaZ – requires a calculation
o Do not construct phasor voltage triangle. Disregard instructions to measure phase angle with the oscilloscope.
3. Capture a screenshot of measured values and paste into a Word document entitled “Lab3_Simulation_StudentID”
4. Construct the circuit in Fig. 18-38a with MultiSIM.
5. Measure the following values with a DMM:
o Ic
o Ir
o It
o It – requires a calculation
o theta1 – requires a calculation
o Xc – requires a calculation
o Zeq – requires a calculation
o Do not construct phasor voltage triangle. Disregard instructions to measure phase angle with the oscilloscope.
6. Capture a screenshot of measured values and paste into the Word document entitled “Lab3_Simulation_StudentID”
7. Answer all questions in the “Series RC Circuit” and “Parallel RC Circuit” sections on pg. 555 in this same document.
8. Upload file “Lab3_Simulation_StudentID”
"Looking for a Similar Assignment? Order now and Get 10% Discount! Use Code "GET10" in your order"
